Meaco DD8L Manual de Instruções descarregar pdf (Página 12)

EMPTYING THE WATER

Continuous Drainage

When the water container is full:

An alarm signal will sound

The Empty Tank LED will flash

The dehumidifier will stop automatically.

Empty the water container and replace it in the correct position.

The dehumidifier will start to work again.

If the “Empty tank” light stays on and the unit does not start up then the tank is not correctly fitted.

Continuous Drainage

It is possible to connect the drainage hose (included in the box) to the dehumidifier for permanent water

drainage. Simply connect the hose to the drain spout and ensure that the end of the hose is lower than the

drain opening, otherwise the water will not drain and flooding may occur.

Water spigot

If you find that the water does not flow down the hose then check that it is running downhill, is not kinked,

all excess tube has been cut off and is not blocked. If the water still does not flow then make a 4mm hole,

30mm from the spout in the top of the hose. This will balance out the air pressure and allow the water to

flow.

When you no longer wish to use the permanent water drainage, disconnect the drainage tube from the

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Sem comentários

Meaco DD8L Manual de Instruções Página 12